Take the old cable off the springs to remove both the cable and springs. Pull the dishwasher out from the cabinet.
Before starting this repair, disconnect the power from the dishwasher and remove the bolts holding the machine in place. Replace both using this door spring and cable kit. Regular use and repeatedly opening and closing the door can cause the springs to stretch or the rope to fray on the cable, both of which lead to failure of the tension system. If the spring or the cable fails, the door will fall and possibly break or land on a foot causing injury. The door spring and cable provide the tension needed to keep a dishwasher door from falling all the way to the floor when it is opened. Check how the door opens and closes, and, if everything is OK, collect the kitchen appliance and connect it to the mains.Thermostat | Defrost Heaters | Timer | Control Board To break such connection, you will have, as a minimum, to break a strong cable that consists of a synthetic fiber. So what have we got? The spring is firmly applied to the groove, and the cable is securely attached to it, too.
Instead of these details, you can use a steel wire hook, but in this case, the connection will not be so reliable. Tie the end of the cable with a knot so that the screw-nut and the shim do not slip off. Take the end of the cable that leads to the spring, put a shim and the screw-nut on it.Tighten tightly so that the washers do not move to the right and left. Put a shim on the thread, and then rotate the screw-nut, firmly connecting the bolt with the spring.The bolt thread should almost completely come out of the spring. From the back of the spring, insert the bolt so that it passes through the shim inserted into the spring.Retreat from the edge of the spring three turns and insert a shim with wide margins.At the end of the groove from the back wall, drill a hole for the bolt.Remove the spring and cable from the groove so that these parts do not interfere your repair work.
#HOW TO REPLACE A DISHWASHER DOOR SPRING HOW TO#
How to eliminate the door (spring) breakage of the Bosch dishwasher: Methods and useful advice from users The right and left products must have the same color.
#HOW TO REPLACE A DISHWASHER DOOR SPRING INSTALL#
At the same time, it is not necessary to install the original products (but it is recommended). This is necessary to ensure an equal coefficient of tension. When replacing, both springs have to be designated with the same article.During operation, the tension coefficient gradually decreases and this leads to a difference in the old door spring. This markup is placed on the wall that allows a user to get information about the parameters. The door springs of the dishwasher are marked with a colored marker on the rear panel of the appliance.The cable system is automatically suspended by the door lever.Ī few important points that can lead to breakdowns in the future: The cord has to be firmly fixed with pliers in the set position.It is necessary to prevent any friction against the pallet that occurs during operation.ĭuring operation, the door must be slightly opened to create a tension of the cable. Fixe its part in one position using the pliers. The cable holder is suspended, as shown in the photo below.Installing a new spring in the Bosch dishwasher After that, the cord and the spring can be removed. For this purpose, a certain sequence of activities is carried out. The entire cable system passes a dismantling procedure.In some cases, there is a grip and if you continue to pull, the fastener will break. There will be some resistance by fixing, but you can ignore it. Pull the lid of the guide cord towards yourself.When this task is completed, you can see the following situation. When removing, it is required to move the surface to the side carefully, so as not to cause damage to the structural elements. It is installed due to the special latches.